Kenwood Tk 360G Programming Software3/16/2021
This cable is used for connecting the TK-370G display unit Use an antenna connector adapter SMA(f).Neither is any liability assumed for damages resulting from the use of the information contained herein.
Press The functions the FPU programs to the function keys are each key to activate its auxiliary function. Display (TK-370G only) Used to temporarily switch transmission output to low power. Turning the function on enables: HiLow, LowLow Key states are backed up, except in the PC mode when they are reset. Option Signalling (DTMF2 tone) This transceiver has a battery warning feature. If low voltage Built-in DTMF decoder is available for option signalling. ![]() PC or compatible) with the interface cable (KPG-22). Hold down the Side1 and Side2 switches on the TK-360G (Connection is the same as in the PC Mode.) 370G, and press the power switch. If you press the (Since the TK-360G does not have a display, check the Side2 switch again (while the checksum is displayed), checksum with the FPU (KPG-56D).) PROG XXX. E30-3411-05 (TK-370GTK-860G862G) E30-3410-05 (TK-370GTK-360G370G) PTTRXD PTTRXD PTTRXD REMOTETXD REMOTETXD REMOTETXD Cloning cable Fig. Self Programming Mode (TK-370G) Write mode for frequency data and signalling etc. ![]() Side2 Data clear Home Channel LAMP7 TK-360G cannot be selected. Display Character KEY35 Scan DELADD MON23 TK-360G cannot be selected. Home Channel KEY37 Group Down MON24 TK-360G cannot be selected. ![]() TK-360G 1. Remove the two knobs and three round units 2. Frequency configuration The first IF signal is passed through a four-pole monolithic The receiver utilizes double conversion. The first IF is 49.95 crystal filter (XF1) to remove the adjacent channel signal. The first local oscillator The filtered first IF signal is amplified by the first IF amplifier signal is supplied form the PLL circuit. Control Circuit The battery voltage is monitored by the microprocessor The control circuit consists of a microprocessor (IC13) and (IC13). When the battery voltage falls below the voltage set by its peripheral circuits. It controls the TX-RX unit and transfers the Low Battery Warning adjustment, the LED flashes red to data to and from the display unit. The signal from keys and channel selector input to microprocessor directly as shown in fig. Channel selector KEYAD LAMP IC13 MONI 100k TK-360G CN501 TK-370G Fig. Control system. Output -127dBm0.1V to greater than -47dBm1mV Power Meter Input Impedance 50. E37-0851-05) 1. Antenna connector adapter The antenna connector of this radio uses an SMA terminal.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |